Testicles between my toes at the devils backbone
Teaching quads a lesson
I have this Big Red at school I have been working on for this guy. overhauled it, replaced bearings etc. Now when I hold the shifter down, it wont just sit there like it should, I can hold it down and drive. Normally you can't move, kinda lik you are in neutural. I have adjusted the clutch everyway I can. Help anyone???
Russ
TF 07,08,09,10,11,12,13,14!
Raffa's IceFest 08, 09, 10,11,13!
SAY IT!!!!!BUD LIGHTS AND RED LIGHTS!!!!!!
Putting Priorities in Order, Busier than ever.
Catch me if you can
Did you have the right side case off ( clutch cover )? If so, did you put all the parts back in correctly?
The adjuster is on the clutch cover towards the back. If it's the same as a 250sx ( I can't remember right now, too tired ), then you turn it counter clockwise until slight resistance is felt. Then turn it clockwise 1/8th a turn ( on 250sx's you turn 1/4 turn ), then tighten the lock nut down and you should be good to go.
Howdy
Testicles between my toes at the devils backbone
Teaching quads a lesson
I've tried adjusting it, and I havent had the cover off. I only overhauled the topend. I know the clutched are bad, I just dont want to get that deep into this, and he dosent want to put the money into it yet. But it dont matter what way I turn the adjuster, it never changes.
TF 07,08,09,10,11,12,13,14!
Raffa's IceFest 08, 09, 10,11,13!
SAY IT!!!!!BUD LIGHTS AND RED LIGHTS!!!!!!
Reply With Quote