I went thru my carb because it was to rich, fouling up the plug with gas? The carb looks very clean. I adjusted the needle at the top of the carb which makes gas rich and lean, it was set to low and adjusted to 2nd slot (supposedly where it should be). I put a new plug in, it does not have any gas on it but it looks black, carbon fouled after riding it a short time. Do I need to keep riding it more to see what the plug looks like in a few days? what do you suggest?
thanks guys


Reply With Quote
. I think I shall have one this weekend.
That pic is about 4 years old just a couple of days after I got my atc. I hadn't checked any part of it though I figgered it was good to ride but as you can see it was far from it. I had to put in a new piston, air cleaner, oil strainer, gasket set and clean out the muffler that looked like a smoker's lungs. After I thought I cleaned it out with degreaser and draano, it still did that for a little while. The oil filter looked like a small brake drum with the shoes attached to it instead of the axle. That was about 1 cm of crud in there. This was taken with a concord 1.3 megapixel camera. How time flies.