Results 1 to 7 of 7

Thread: Where is the oil filter on a 200s?

  1. 04-01-2006, 10:11 PM #1
    DavidBulzan
    DavidBulzan is offline New to the board Arm chair racerNew to the board
    Join Date
    Aug 2005
    Location
    Wake Forest, NC
    --
    50

    Where is the oil filter on a 200s?

    where is the oil filter on a 200s? Does it have one?
    Reply With Quote Reply With Quote
  2. 04-01-2006, 10:31 PM #2
    hancadam's Avatar
    hancadam
    hancadam is offline Got The Holeshot Arm chair racerJust too addicted
    Join Date
    Jan 2005
    Location
    Tennessee
    --
    850
    There is a bolt cover on the bottom that looks the same as the valve covers. On the left side remove it and its behind there I believe.
    Reply With Quote Reply With Quote
  3. 04-01-2006, 10:46 PM #3
    pinkerchook's Avatar
    pinkerchook
    pinkerchook is offline New to the board Arm chair racerNew to the board
    Join Date
    Dec 2005
    Location
    Tulare California
    --
    10

    200s

    The oil drain plug is on the left side of the bike when you are siting on it. It is just under the shifter lever. There is a spring and wire filter behind the cap.
    Honda 350x sold
    Honda 200x sold
    Honda 250r sold

    1985 Honda 250r
    Reply With Quote Reply With Quote
  4. 04-01-2006, 11:05 PM #4
    RichinMO's Avatar
    RichinMO
    RichinMO is offline At The Back Of The Pack Arm chair racerAt the back of the pack
    Join Date
    Aug 2002
    Location
    Waynesville, MO
    --
    321
    It's not really a filter, it's a screen that you clean and re-use. Looks like a thimble made of wire mesh.
    1985 ATC250ES
    1985 ATC250SX
    1984 ATC200S "Little Red" - Trailer hitch, Hondaline: Front and Rear Racks, Cooler Rack, Tripmeter, HL Grille, Rubber Footpeg Covers, Mudflaps.
    1985 ATC70
    2008 CRF230L - Dual Sport
    2016 TRX500 Foreman Rubicon Deluxe
    Reply With Quote Reply With Quote
  5. 04-01-2006, 11:48 PM #5
    TravEX's Avatar
    TravEX
    TravEX is offline Power User Got the holeshot
    Join Date
    Jan 2003
    Location
    NE Arkansas
    --
    2,344
    yeah, that's it. Hmm, that remiinds me, time for a oil change, hehe.

    actually there is another oil filter, you have to remove the right crankcase cover, it's the oil filter rotor. I have never changed/cleaned it on mine, and it's rarely ever mentioned here, so I don't worry bout it. The manual calls for the inside of the oil filter rotor cover and rotor to be cleaned and a new gasket used. I've never even seen this gasket listed when searching for parts. Again, I don't worry bout it, maybe someone else has some input.

    Later

    Travis
    Last edited by TravEX; 04-02-2006 at 12:00 AM.
    36 yo, Apple geek, married with kids, conservative. If you are a GUN OWNER and not a member of the NRA, SHAME ON YOU! JOIN!

    Gun control is not about guns, it's about CONTROL!

    My Rags
    85 ATC70,85 ATC70,85 ATC110,83 ATC185S,85 ATC250ES,02 400EX,04 Polaris ATP 500
    Past rags:2000 Scrambler 400, 86 350X, 86 250R, 84 200S, 97 ATK260LQ
    Reply With Quote Reply With Quote
  6. 04-02-2006, 12:06 AM #6
    Yamahauler's Avatar
    Yamahauler
    Yamahauler is offline Power User Got the holeshot
    Join Date
    Sep 2004
    Location
    Brandon, Manitoba
    --
    2,209
    Yea, on my 200s the oil rotor filter has never been cleaned. the only bolt ever taken out of that motor is the drain plug. I think the carbs been cleaned less than 5 times in its whole existance too.
    Reply With Quote Reply With Quote
  7. 04-02-2006, 12:06 AM #7
    DavidBulzan
    DavidBulzan is offline New to the board Arm chair racerNew to the board
    Join Date
    Aug 2005
    Location
    Wake Forest, NC
    --
    50
    Thank yuo everyone! Time to check it out..
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //