what is the typical pricing on a honing job on a cylinder. Very light scratches near the bottom of the jug.
How about an entire valve job
First Time Rider
Arm chair racerNew to the board
what is the typical pricing on a honing job on a cylinder. Very light scratches near the bottom of the jug.
How about an entire valve job
At The Back Of The Pack
Arm chair racerAt the back of the pack
I got my cylinder bored out 2mm for 30 bucks at my local machine shop.
-'86 ATC 250SX: No longer mine...Complete 350X front end, Corbra Megaphone system, 350X carb with UNI dual stage foam & outerwear bolted driectly up, Powroll/Rocky 260cc bore 10.5 to 1 compression piston.
First Time Rider
Arm chair racerNew to the board
I hone my own cylinders. I if I had someone else hone a cylinder I would only pay $15.00 to $25.00. To bore the cylinder it cost about $50.00 and boring a cylinder takes much more time.
New to the board
Arm chair racerNew to the board
i got mine honed for $10 from a local machine shop here in albany. I was totally satified with the job.
Registered User
New to the board
Great post olive! But I don't know anything about the prices of honing. According to me you should check it out from local machinery shops near your home. Thanks.
At The Back Of The Pack
Arm chair racerAt the back of the pack
shanefoster, you seem to like bringing old honing threads back to life.
1985 ATC250sx
1984 ATC200s
1984 ATC200x
HONDAS FOR LIFE!!!
Reply With Quote