Results 1 to 5 of 5

Thread: fly wheel help

  1. 05-31-2006, 06:03 PM #1
    als 200s
    als 200s is offline Registered User New to the board
    Join Date
    May 2006
    Location
    rehoboth beach delaware
    --
    4

    fly wheel help

    hi all I just recently got into three wheelin when i puchased a 1984 200s not running and looked terrible, well i got it running and redid fenders, well my problem is after i run it 3-4 times my flywheel comes loose not knowing it is loose when i try to start it again i strip the key any suggestions. thank you
    Reply With Quote Reply With Quote
  2. 05-31-2006, 07:22 PM #2
    jonnyb
    jonnyb is offline New to the board Arm chair racerNew to the board
    Join Date
    May 2006
    Location
    North America
    --
    22
    you could proably go to your local dump or a second hand atv parts place and find a fly wheel, thats what i did when i had trouble with my fly wheel
    My machines:

    1985 350x-my baby
    1986 250sx-resto
    1983 200s-my old beater
    Reply With Quote Reply With Quote
  3. 06-01-2006, 12:07 PM #3
    Unclediezel's Avatar
    Unclediezel
    Unclediezel is offline Got The Holeshot Arm chair racerJust too addicted
    Join Date
    Oct 2005
    Location
    Pennsylvania
    --
    863
    The flywheel has to fit tightly on the crankshaft, ---Tightening the bolt is not enough....
    Check the crank for signs of damage , before laying out the cash on a new flywheel.
    Buy American! Unless your only option is a HARLEY.

    A customer walked in to my shop and Impatiently stated "My car doesnt start, Whats the problem?"I responded with a smile-"Yep that sounds like your problem alright"----
    Reply With Quote Reply With Quote
  4. 06-01-2006, 12:33 PM #4
    Air-cooled-R's Avatar
    Air-cooled-R
    Air-cooled-R is offline At The Back Of The Pack Arm chair racerFirst time rider
    Join Date
    Oct 2005
    Location
    West Monroe, LA
    --
    167
    when you tighten the nut on your crankshaft to hold the flywheel on, put some loc-tite on there. Make sure you DON'T USE THE RED KIND! You should use green or blue, probably blue its a lil tougher, but the red loc-tite requires heat to remove the nut.
    My bikes:
    -1982 honda 250r
    -1999 HONDA 300 Fourtrax 4x4 "The Tank"
    -2001 harley 1200 sporty
    Reply With Quote Reply With Quote
  5. 06-02-2006, 04:19 AM #5
    jason 32's Avatar
    jason 32
    jason 32 is offline Just Too Addicted Arm chair racerJust too addicted
    Join Date
    May 2006
    Location
    illinois
    --
    743
    im assuming your talking about the magneto ? yes -a new woodruff key
    and RED locktight!!! this should wok but make sure you are getting it tight enough!!!!!!!
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //