Need carb help on YTM200ERN

[mark38090]

i took it apart to clean and can't get the neddle set that goes through the slide back together correctly. There is the needle, a c-clip and another type of "spring clip" of some type and the large spring for the throttle. I looked at the diagram on here, and the schematic shows these three pieces, but It's smarter than me and I can't figure it out.

[freewheel3]

Put the c-clip on the middle notch on the needle.
Drop the needle in the slide.
Then use needle nose pliers to insert the "spring clip" inside the slide to hold the needle in place. (The "spring clip" lays on it's side in there)
Then, leave the spring on the throttle cable, compress it, get the knob on the end of the cable to sit in the other hole in the slide & then pull up on the spring & the cable will slide through the notch in the slide.
When you are done, the spring will be pushing on the "spring clip", which hold the needle assy. in place.
Kinda hard to describe, but I hope this helps.

[kinkcycle128]

o you have the carb settings for this i have the same wheeler i am restoring
any other parts?

[mark38090]

I have 2 of these bikes, they are great bikes. If you need any help I have quite a bit of experience with them now...