I am tryin to take the motor out of my 85 250 big red es, I have all the bolts out and cant seem to figure out how the drive shaft unhooks can somone help.
New to the board
Arm chair racerNew to the board
I am tryin to take the motor out of my 85 250 big red es, I have all the bolts out and cant seem to figure out how the drive shaft unhooks can somone help.
Testicles between my toes at the devils backbone
Teaching quads a lesson
You got to get the U-joint apart. I'm having the same problem, but then again I need to actually work on it lol.
TF 07,08,09,10,11,12,13,14!
Raffa's IceFest 08, 09, 10,11,13!
SAY IT!!!!!BUD LIGHTS AND RED LIGHTS!!!!!!
Administrator
The day begins with 3WW
do you have the rear end off of it. Take the rear drive gearbox off, and you should be able to pull the driveshaft right out
RIP - Yamahondaman!! You will never be forgotten!
RIP - Sam Brehm!! Gone but NEVER forgotten!
RIP - Sandpuppi101 - You will live on in my mind - I miss you friend!
Power User
Roostin Away
ITs Spring loaded. YOu have to move the boot over, and pry it the shaft tip/motor end backwards towards the rear differential. While its pried back you have to pull it out. There should be enought clearance. Worst case, Take the rear axle tube and diff assembly loose. Not the swing arm. 2 bolts on the right side lower swingarm and 4 bolts on the front side of the diff where the shaft hooks to the rear diff. Then the lower shock bolt. You would definately have slack then. Its very easy to get back on. Much easier than getting it off. I have never taken the U-Joint apart. Took the whole shaft out and installed it as a whole.
Clay
Clay Whitman
Newnan, GA
AMSOIL DEALER
My Toys
2008 Yamaha Rhino 700 SE
1999 Larson 226 SEI 5.0L EFIVolvo I/O LOVE IT
New to the board
Arm chair racerNew to the board
ok thanx guys
Reply With Quote