First Time Rider
Arm chair racerNew to the board
am removing the rotor from a 200e have the flywheel remover. Need to change the cam chain.
it is just a long screw basically. Do i just screw it in and the flywheel backs off?
I had it pretty tight and it doesnt budge. I tapped with aand even put the pin through the end of the rod and stuck a long heave screwdriver through to hold then was hitting the end of the wrench with a
Seem right?
Registered User
New to the board
well the object of the tool is to push on the crank pulling off the crank while you tightent the tool but i would go a little at a time and inspect the threads if you think it stripping out have you tried to soak it a little in wd 40 or penatrating oil? good luck
you need to have a fast bike and a good pair of goggles to catch me !
85 250r dura blue axle kn filter weisco piston boysen reeds dg exhaust etc..
83 alt 125
84 alt 50
and a extensive collestion of three wheeler colectibles
Reply With Quote