Results 1 to 10 of 10

Thread: Need a hand finding a 250r motor part

  1. #1
    Join Date
    Feb 2004
    Location
    CUYAHOGA FALLS, OHIO
    --
    1,242

    Need a hand finding a 250r motor part

    I need the collor that goes behind the sprocket that the counter shaft seal rides (seals) on. There is a oring that rides inside the collar. Dealer cant get the part. Its shows on the diagram. But no listing. Is there any aftermarkets for this???? I could reuse my old one but wear the seal rides its a bit worn.
    Any ideas would be great. Thanks!!!
    Max
    3-85 ATC 70
    86 ATC 250R
    86 WETBIKE
    01 KX250
    2011 KAW SXR800- 35YR EDITION
    05 HERITAGE/SPRINGER/SOFTTAIL

  2. #2
    Join Date
    Jan 2004
    Location
    Palmetto,Florida
    --
    2,300
    HUMMMM ?? i can't believe they don't have that .. is it the same from 85-89 ?
    "07" DR650 Suzuki Dual Sport

  3. #3
    Join Date
    Jun 2004
    Location
    potsdam ny
    --
    1,227
    1985 Honda ATC250R drag trike with s/t kit and full drag CR hybrid motor and drag chassis...
    1986 Honda ATC250R daily rider fully modded engine, +4 swinger,etc...
    1997 Polaris Storm 800 triple, boyesen reeds, dg individual silencers, 240 studs, 123mph on radar...

  4. #4
    Join Date
    Feb 2004
    Location
    CUYAHOGA FALLS, OHIO
    --
    1,242

    Nope

    Yes it is the same for all years. If you go on bike bandit and check under transmission. Its the two parts directely behind the sprocket. There are no #'s. WTF! Anybody have any clues?
    3-85 ATC 70
    86 ATC 250R
    86 WETBIKE
    01 KX250
    2011 KAW SXR800- 35YR EDITION
    05 HERITAGE/SPRINGER/SOFTTAIL

  5. #5
    Join Date
    Nov 2002
    Location
    hinesville ga.
    --
    200
    Quote Originally Posted by max
    Yes it is the same for all years. If you go on bike bandit and check under transmission. Its the two parts directely behind the sprocket. There are no #'s. WTF! Anybody have any clues?
    try service honda 800.828.5498

  6. #6
    Join Date
    Jan 2006
    Location
    conesus lake NY
    --
    11,894
    Blog Entries
    1
    try under crankcase part 21 & 7 thats them...

  7. #7
    Join Date
    Feb 2004
    Location
    CUYAHOGA FALLS, OHIO
    --
    1,242

    Thanks Bryan

    Your a bad dude. Yes, the show them in the trans section with no numbers. But they also show them in the crankcase section w/#'s. Its actually no's 22 and 9. Thanks guys for all the help. I just called up and ordered them. My motor will then be complete.
    3-85 ATC 70
    86 ATC 250R
    86 WETBIKE
    01 KX250
    2011 KAW SXR800- 35YR EDITION
    05 HERITAGE/SPRINGER/SOFTTAIL

  8. #8
    Join Date
    Jan 2006
    Location
    conesus lake NY
    --
    11,894
    Blog Entries
    1
    i just recently looked for that part for a tri z and there discontinued too. but the yz's have the same part but not the number.. sometimes it just takes a little diggin.

  9. #9
    Join Date
    Jan 2006
    Location
    conesus lake NY
    --
    11,894
    Blog Entries
    1
    that 22mm collar is #7
    #21 is the o ring for the collar
    #24 is the seal itself

    #22 is the left main seal for the crank
    and #9 is just a 10mm washer that covers the the seal for the actuator arm

    http://houseofmotorcycles.bikebandit...me~ATC250R.asp

  10. #10
    Join Date
    Feb 2004
    Location
    CUYAHOGA FALLS, OHIO
    --
    1,242

    Yeah

    I was on www.servicehonda.com. So I think the #'s are alittle different.
    3-85 ATC 70
    86 ATC 250R
    86 WETBIKE
    01 KX250
    2011 KAW SXR800- 35YR EDITION
    05 HERITAGE/SPRINGER/SOFTTAIL

//ArrowChat Integreation Code //