how much power?

[84honda200s]

i had my engine apart to change the gaskets and while i was at it i measured my piston because i was told by the old owner it was bored out to 300cc. it measuers out to 2 5/8 inches witch is almost 67 mm. stock is 47 mm i believe. so that makes it almost 20mm over. how much power did it gain? i dont know a whole lot about how many hp is in a certin amount of cc.

[3leggeddog]

there is no set amount of power per cc.not rel sure if thats what your asking,but a poorly tuned 300 r cooled air could make less power then a finely tuned one.

[200xcellent]

boring isnt really a power gain by itself.

[84honda200s]

there is no set amount of power per cc.not rel sure if thats what your asking,but a poorly tuned 300 r cooled air could make less power then a finely tuned one.

true i was just wondering how much hp my bored 200 was giving out. but i can tell you 1 think you can tell its bored. when it cold out it runs like crap till she gets warmed up. then it takes off like no tommarow.

[84honda200s]

boring isnt really a power gain by itself.

i know there is alot of other stuff too. i really dont want power. i have enough of it for what i do.

[SWIGIN]

stock is not 47mm......thats smaller then a 110

65mm is stock bore on a 200

[short4stuff]

If its on a 200 honda trike, stock bore is 65mm max is 67mm which only brings it to liike 198cc . You wont feel the difference in power.

[84honda200s]

im just going by this. http://www.3wheelerworld.com/1984HondaSpecpage.shtml like i said i dint know to much about bores and stuff like that. but thank you for giving me all the info you have givin me.