At The Back Of The Pack
Arm chair racerAt the back of the pack
Anyone know if a rear master cylinder from a TRX 250R will fit an ATC 250R?
They look pretty similar, though I have not looked at a TRX rear master in person.
I would think the guts would be the same, at least. Are there any other than the stock one that will bolt on without much trouble? Even if you have to modify the rod, that would be fine with me. I need a new one for my R, or a rebuild kit for my original one.
Last edited by InPiEcEs; 09-26-2006 at 11:11 PM.
One piece at a time. Status: The Beast is Done..06-23-07
Back in the saddle again
Currently owned rides:
My sleds, and.........
1995 CBR600F3
1976 Kaw 400 triple-smoker......SOLD
1986 250R...owned since 1990
06-23-07........the R is finally done!!!
ESR pipe, Aktive reeds/CR cage, 38mm PWK, +4 Dominator
mild clean-up porting, an open K&N, CR and YZ calipers.......among other things
First Time Rider
Arm chair racerNew to the board
I rebuilt my master on my 350X... It seems to work as good as it's suppose to. I don't know about 250R's thought.. sorry man. I bought the kit at Honda but it was kind of expensive.. That was the only place I could get one, but you may find an aftermarket kit for an R.
1985 350X
1986 250ES Big Red
(previously owned) '89 Cr 250R
2008 Toyota Tacoma Double Cab
Check my feedback before buying from me
Catch me if you can
dennis kirk has rebuilds, thats what Im gointo order this weekend
First Time Rider
Arm chair racerNew to the board
No the trx master does not fit. But the guts are the same. Luckily my dad found a nice atc one on ebay.
Reply With Quote