TriZ rear sproket lock nuts question

**Ryah** · 10-03-2006, 12:57 PM

Are the two locking nuts that hold the sproket on/tight threaded backwords. IE to loosen them up from the back of the bike you would be going towards the ground. or is it normal righty tighty lefty loosey. I've got some play in my rear sproket, is this normal? Any info from TriZ gurus on this? The manual I have with the bike doesn't have anything on this.

**Bryan Raffa** · 10-03-2006, 01:28 PM

check the rear sproket hub, theres a steel incert in side the alum. hub they tend to get play in them when you run it with the nuts loose..best fix for that is to run a banshee hub,As they dont have the steel incert in them and is a one pice hub.

**Ryah** · 10-03-2006, 04:48 PM

Thanks for the info. I'm still going to have to take the lock washers off to check. Do you know if they are a regular thread. IE turning to the right tightens, or are they turn to the left to tighten. I'm going to be using a

and a punch to take them off at this point so if I'm going the wrong way they're going to be really tight. I just need to know which way they spin to come off.

**TimSr** · 10-03-2006, 05:12 PM

They are a regular thread. Banshee and Blaster sprocket hub will replace it.

**Bryan Raffa** · 10-03-2006, 05:36 PM

6 bolt banshee...some were 4 bolt on a certin year

Thread: TriZ rear sproket lock nuts question

Thread Tools

TriZ rear sproket lock nuts question