New to the board
Arm chair racerNew to the board
Seat cover HELP !!!!!!
I just purchased a new seat cover form Ebay, and it looks great and seams to fit. The problem i am having is that the electric staple gun i have won't penetrate the plastic! I have tryed two different ones and either works. Is there a easy way to put this cover on or a special staple gun that i need. Any suggestions would help, thanks
Just Too Addicted
Arm chair racerJust too addicted
When I did the seat on my Z I just used a normal hand-held manual staple gun. It worked really good for me. Go down to the hardware store and get a BIG handheld, it should work.
Always finding new and exciting ways to not give a hoot in hell
Catch me if you can
Yup I bought an electric one and it didn't do squat. The handheld one I had worked better. An air operated one works the best.
Billy
New to the board
Arm chair racerNew to the board
ok well i guess i am going to have to get a air powered one, thanks for the info
First Time Rider
New to the board
same thing with me. baught a electric staple gum for nothing, wound up taking it to a canvis shop and they did it for about what the staple gum cost me. and did a great job.
Power User
Got the holeshot
try getting different staples
New to the board
Arm chair racerNew to the board
ya just tryed that thanks i think i am jsut going to bring it in
At The Back Of The Pack
Arm chair racerAt the back of the pack
Heat the plastic seat up with a hair dryer, it will help you out alot. dont heat it enough to melt it, just enough to soften the plastic. You can also use the hairdryer to warm up your seatcover and make it more plyable.
Barry
There are no stupid questions, but there are alot of stupid people out there that ask questions.
None of us are capable of screwing things up as bad as a group of us.
"NON SIBI, SED OMNIBUS"
Reply With Quote