Results 1 to 5 of 5

Thread: yt-125 tri moto carb connections

  1. #1
    Join Date
    Nov 2006
    Location
    New York State
    --
    3

    Question yt-125 tri moto carb connections

    My son just bought this 3-wheeler the other day and now has a problem. It seems it ran well when he got it, but somehow he and his buddy seem to have disconnected several of the hoses that attach to the carb. Now of course, they have no idea where to reconnect everything. I ride a Honda VTX1300 bike and have no experience with oil-injected, two stroke engines and carburation. Can anyone out there tell me where the hoses attach?

    The main gas line from the run/res valve is still attached, but, there are three small ports not connected, two opposing plastic ones about midway up the carb, and one copper port near the bottom . Normally it would be easy to just take the unconnected lines and see where the reach, but they completely removed the lines because they wanted to replace them and now have no clue where they took them off.

    Thanx in advance for any info you can provide.

  2. #2
    holmstrom is offline At The Back Of The Pack Arm chair racerFirst time rider
    Join Date
    Nov 2005
    Location
    bryan ohio
    --
    221
    The two opposing black plastic ones are vent tubes. The oil injection tube is the one on the side close to where the carb connects to the intake.
    2 125 yamaha tri motos
    1 yt175
    1991 blaster

  3. #3
    Join Date
    May 2006
    Location
    illinois
    --
    743
    from what mine looks like the fuel goes in on the left side , others are vent tubes - they just run down to the ground
    the oil is injected in to the reed block

  4. #4
    Join Date
    Nov 2006
    Location
    New York State
    --
    3
    Thanx guys, i'll try to reconnect the way you've stated and see if it works.

  5. #5
    Join Date
    Nov 2006
    Location
    New York State
    --
    3
    It runs fine now!!!!!!!!! Thanx again.

//ArrowChat Integreation Code //