New to the board
Arm chair racerNew to the board
I am gonna rebuild a 200s motor i got. I have a Gasket set. Wiseco 12;1 piston, carb rebuild, anyway. Can i just put in the 12:1 just like a stock piston or does it have to be clearenced and then be sure the valves wont hit the piston??? How do i do it? Are they a pain or just bolt in...??
On my 200x, i had a 10.25/1 piston in it, and had to do nothing but hone out the cylinder and put the rings in, i wouldnt think the 200s or any other would have to be "clearanced" for the piston, although i may be wrong, only thing you could do is ask a dealer, or put it in the cylinder, push the cylinder down, put the valve component on and see if it hits. thats my only guesses. Hope this helps.
Brad
Within Arms Reach Of The Master
Arm chair racerLord of the trike
Anytime you stick a 12:1 in a machine you should check it. If your installing a cam too I would check it with out question.
'02 Honda 416ex - A seasoned blend of 11 herbs and spices
'04 Honda Recon - The yard machine and snow plow
'88 Honda CR250R - Another chapter in my torrid all terrain affair
Reply With Quote