New to the board
Arm chair racerNew to the board
Hi all,
I'm new to the forum and 3Wheelers and need help with my Yamaha trike.
Its yellow.
2 stroke
no suspension in front or back
single brake in the rear
175cc or 200?
I have the trottle, choke connected correctly, but a small cable seems to be cut on the front right side of the engine. These trikes have an auto clutch right? What cable could this be?
Thanks,
Any help would be great.
Dave
Loves Corn.
Catch me if you can
there should be a stamp on the bottom of the cylinder on one of the sides that tell the CC's,, sounds like a 175
Power User
Roostin Away
If it a 2 stroke, it is a 125 or a 175. The 200 are 4 strokes and have suspension on the front.
1984 Yamaha YTM-225DX
1985 Tri-Z 1985 Tecate 1984 Tri-Zinger and 1986 ATC250R projects
Yamaha 3-wheeler owners club Join now!
Official 3WW Yamaha 3-wheeler owners group
Québec 3-wheeler riders group
At The Back Of The Pack
Arm chair racerAt the back of the pack
The 175's had front suspension.
Loves Corn.
Catch me if you can
does it look like this? its got to be a 125cc
http://www.3wheelerworld.com/pppics/...unktrimoto.jpg
New to the board
Arm chair racerNew to the board
Yes it looks similar to that. I assume its a 175cc because the previous owner said he thought it was and the cylinder is really large for a 125cc. Any idea on what that 3rd cable would be?
At The Back Of The Pack
Arm chair racerAt the back of the pack
On the 200cc there is a compression release to make it easier to pull start...
1984 Honda TRX200
1985 Yamaha 200ERN ( two of these now)
1985 Honda 250SX
1991 Suzuki LT230
2003 Honda Rancher 350ES
Loves Corn.
Catch me if you can
the first pic is a 175 the second is a 200
http://www.files.3wheelerworld.com/p...110ytm1753.jpg
http://www.3wheelerworld.com/pppics/...4xtrimoto2.jpg
is it chain drive or shaft?
New to the board
Arm chair racerNew to the board
Could cable be reverse? I took the cover off (4 bolts) and inside the cable runs to a little spool and two vacum lines on this square thing. Again its located in the front right section of the crank case.
Yeah it looks like that 175 but with a ridged front end.
I'm like an Original Gangsta...but a post whore instead.
The day begins with 3WW
It sound like a YTM 125 Tri Moto.Now if it was a YTM 175 Tri Moto then the front suspended forks have been swapped out for some reason.
My old 1985 250R http://www.flickr.com/photos/24898661@N07/show/
Feedback http://www.3wheelerworldforums.com/s...feed+back+edog
Currently trikeless
Power User
Lord of the trike
I agree. And that cable you are talking about could be part of the oil injection system they came with.Originally Posted by edog
1984 Yamaha YT 60 Tri Zinger(current project)
1983 Yamaha YTM 200 (rear suspension kit)..... long term project
2004 BMW R1150R
1972 Honda CT 70
2007 Lifan 110
I'm like an Original Gangsta...but a post whore instead.
The day begins with 3WW
The only way to find out what displacement it is to look on the cylinder head.
My old 1985 250R http://www.flickr.com/photos/24898661@N07/show/
Feedback http://www.3wheelerworldforums.com/s...feed+back+edog
Currently trikeless
At The Back Of The Pack
Arm chair racerFirst time rider
What you have is a 125. I have this trike and If the cable you are talking about is the same I'm thinking, then yes, it is for the autolube injection system. if you plan to run the bike using this system you need to replace it, but you can always mix the gas and oil straight in the tank and not worry about the cable. just make sure that no air is getting into the the engine , so plug the caps that you are not using.
BIKES CURRENTLY IN MY GARAGE
1990 XR80R
1983 CR60R
1986 250SX
1985 250R
Reply With Quote
