At The Back Of The Pack
Arm chair racerFirst time rider
I tried using a razor blade with a handle type deal and going at a very slight angle scrape the old gasket off but it tends to gouge if I'm not careful. A wire wheel will just eat the aluminum right up. Any ideas to get it squeeky clean without destroying the surface of the head?
Post Count: Starting over
Arm chair racerRoostin Away
Huffa just made a post about this yesterday. Search.
'85 250SX - My first ever trike and my pride and joy
**Check Out The Whole SX Project Here!!**
'85 350X - 10:1 Piston, performance cam, '86 engline/carb
'85 Powervalved Tri-Z - Fully modded - Soon to have a Corey Sprock 310 kit
'85 250R - Began the modification process. This bike is going to scream! -295cc kit, Ported, Drag intake, 40mil Keihin, VForce reeds, shaved head, PT High Rev pipe, Fat Boy 2 Silencer, +4 Durablue axle, +2 swinger-
Got The Holeshot
Arm chair racerJust too addicted
i use a raazer blade and gasket remover
Reply With Quote