Power User
Got the holeshot
Time for new headset bearings on my 85 Big Red. I got the tapered bearings. After I remove the old bearings and races, do I press the new outer races in the headset, and the small end of the new bearings face each other in the frame? and then install the stem?
Also, does this have to be removed (the bottom part the screwdriver is pointing to), it seems liked it is fixed on there?
Thanks,
Travis
Last edited by TravEX; 03-01-2007 at 11:01 PM.
36 yo, Apple geek, married with kids, conservative. If you are a GUN OWNER and not a member of the NRA, SHAME ON YOU! JOIN!
Gun control is not about guns, it's about CONTROL!
My Rags
85 ATC70,85 ATC70,85 ATC110,83 ATC185S,85 ATC250ES,02 400EX,04 Polaris ATP 500
Past rags:2000 Scrambler 400, 86 350X, 86 250R, 84 200S, 97 ATK260LQ
Power User
Got the holeshot
Bump......
36 yo, Apple geek, married with kids, conservative. If you are a GUN OWNER and not a member of the NRA, SHAME ON YOU! JOIN!
Gun control is not about guns, it's about CONTROL!
My Rags
85 ATC70,85 ATC70,85 ATC110,83 ATC185S,85 ATC250ES,02 400EX,04 Polaris ATP 500
Past rags:2000 Scrambler 400, 86 350X, 86 250R, 84 200S, 97 ATK260LQ
Reply With Quote