Yamaha 1984 Tri Moto 200L Clutch Diagram Needed + a few questions

[timex69]

Hey
I've had this Yamaha 200L for quite some time and got it running a few months back but I cannot figure out why I cant adjust my clutches so i've come to the conclusion that i must be missing something. People claim to back the adjuster screw out for the clutches then turn it in until you feel tension but I cant feel any tension. Could someone tell me what this could be

I need a scan of the clutch section out of a good repair manual (dont refer me to bike bandit as it doesnt give a close enough view), make sure it includes the adjustor and outside case so I can see if im missing something. If you dont want to post the scan up here my email address is alex_harman98@pei.sympatico.ca .


Thanks
Alex

[WIkid500]

Download the ytm-200 service manual from the 3WWforums homepage It's all there with instructions

[thefox]

When the cover is off check the arm the adjuster is hooked to, I have had one crack on me when installing the cover. I would adjust the clutch but it still would not work, after I had the cover off a few times I saw the crack.

[edog]

Pm sent........

[timex69]

Hey
The Fox:
The adjuster arm was cracked, i just replaced it and im still having the same problem. I finally did what ive been meaning to do for along time. I bought a clymer manual for my trike. Apparently from what I read your secondary clutch housing cannot have many deep groves, and mine has about 4 really deep ones. So im going to need to replace that. My clutch plates in the primary are only fair so if i can find a decent set of used ones ill buy them or even a new pair because I beleive their only 50 dollars or so to replace I may as well get new ones.

EDog: Your pm box is full, empty it and let me know so I can drop you a line on the parts I need.

PS if anyone has any parts for this trike for sale let me know I am looking for alot of things. List what you have.