Power User
Got the holeshot
My 84 200s is being a pain in the trailprotrailprotrailprotrailprotrailpro. Does anyone have the settings for the carb? I pulled the carb off and put a new O-ring between the intake and the carb. It ran great til I put gas into it and put the airbox cover back on THEN NOTHING. It has spark, compression, and it is getting gas, but it will not run.
ANY HELP APPRECIATED
MIK6 / Mike
TECATE RIDER, HASPIN SURVIVOR!!
Trikefest 02, 03, 04, 05, 06, 07, 08, 09, 10, 11, 12, 13, 14 and beyond
RAFFAs Ice-fest 09, 10, 11, 13, 14, 15
Pensyltucky 09, 12, 13, 14, 15
New England Ride 4/13
New to the board
Arm chair racerNew to the board
hay mik6 go to www.3wheeler.org/tech. click on 185 carb adjestment its the same as a 200s. only two adjestments.
Just Too Addicted
Arm chair racerJust too addicted
For 1984 models the model number is PD 85C
85-on Pd85D
The Main Jet number is 100
The initial pilot screw opening is 2 1/4 turns out
The needle jet clip positon is the third groove
The Float level is 0.49 in. (12.5mm)
The idle speed should be 1400 + or - 100 rpm
At The Back Of The Pack
Arm chair racerAt the back of the pack
Just got mine back to running right I had to put all the old crap back in, come to find out the neddle valve was to short causing it to run way to rich. But as the book says the settings above are right on. Check to see if you have a vaccum leak around the new o-ring, could be the culpret since nothing was changed.
'02 ranxher 4x4 '83 big red '84 110, '86trx70 project, '85 bigred project
Reply With Quote