Tri Z with banshee carrier???

[KingNothing]

Ok.

I started putting my first Tri Z together today and I had purchased a backend from a 2000 banshee. Carrier, axle, claiper, wheel hubs, brake and sprocket hubs. I installed my tri z swing arm which i had streched 8 inches. Went for the carrier only to discover that things arnt lining up. I'm pretty sure ive seen the set up on Tri Z's before. I was told that it was an easy swap out. So what do I gotta do to make things work?

Thanks guys.

[Bryan Raffa]

03 orangshee did it your gonna have to wait for him to awnser.. the banshee carrier mounts to the inside of the swinger and the triz mounts to the outside . Something had to be drilled or bent cant rember witch..

[Bryan Raffa]

I found this,,

i tried the old 87 two bolt carrier setup
it is wider but fits after you spread the mounting tabs...
and you have re drill the bottom hole , its off just a hair

[370banshee]

you can also get a banshe swinger and cut the pivot tube to fit the tri-z rear mount.. they use the same swinger bolt, bearings, and seals... also... the sprocket hubs are swapable too... you can score +8 shee swingers for $129 on ebay from the swingarm shop