At The Back Of The Pack
Arm chair racerAt the back of the pack
got all the bikes out yesterday and when I went to check the oil level on the tri z the bolt is striped out and its not the correct bolt and quick fix ? other then pulling the clutch cover and retapping its 12 pm here and I wanted to go rideing today my hard tail 200s just wont do for todays ride thanks
First Time Rider
Arm chair racerNew to the board
vice grips to take it out maby
83 atc 200
86 lt250r quadracer
First Time Rider
Arm chair racerNew to the board
after you get it out run to the hardware store
83 atc 200
86 lt250r quadracer
At The Back Of The Pack
Arm chair racerAt the back of the pack
no problem with it coming out I am trying to keep it in
I got banned by Ripping People Off
Got the holeshot
jb weld tht bitc
At The Back Of The Pack
Arm chair racerAt the back of the pack
no jb weld that *Edited**Edited**Edited**Edited* is junk I am just going to pull the clutch cover and re tap it
Power User
Got the holeshot
No Quick Fix's , Asking for Trouble .
Do it right the first time !
Just Too Addicted
Arm chair racerJust too addicted
Could I use jbweld to adhere a nut to the top of the oil bolt, then use a socket? Is jbweld strong enough for that? Thanks
Power User
Roostin Away
No, JB weld would never be strong enough to take even the lightest twisting force of a wrench.
THE 80's RAGE! Currently owns:
81, 85 Yamaha Tri Moto 125
83 Yamaha Tri Moto 200 x2
82,83 Yamaha Tri Moto 175 project
85 Yamaha Tri Z 250
84 Kawasaki Tecate 250
84 Honda ATC 70
85 Honda ATC 350X
84 Honda ATC 250R
(2) 84 Honda ATC 200x
82, 83 Honda ATC 185s
81 ATC 200
Lots of other parts and bikes
Just Too Addicted
Arm chair racerJust too addicted
ok, thanks, ill try the easy out first
New to the board
Arm chair racerNew to the board
Take your engine or bike to an autobody shop. They should be able to retap to a bigger bolt . thats the only thing I can think of but probably the best thing.
Reply With Quote