//ArrowChat Code
Results 1 to 3 of 3

Thread: Straightening racks...

  1. #1
    Join Date
    Mar 2007
    Location
    Minnesota
    --
    102

    Straightening racks...

    OK so I finally found a rear rack for my 84 Tri-Moto but of course its bent to heck... I'm thinking about bending it back but dont want to crack anything. Anyone have any ideas on how to straighten this thing out without cracking the bars?

    I was thinking heating the bars up with a torch and slowly bending them back....

    Any thoughts?
    Attached Thumbnails Attached Thumbnails 1.jpg   2.jpg   3.jpg  

  2. #2
    Join Date
    Sep 2003
    --
    21
    That's not bent too bad. It's a low carbon steel - just bend it - shouldn't have any problems. No need to heat it.

  3. #3
    Join Date
    Mar 2007
    Location
    Minnesota
    --
    102
    I'll give it a shot.

    Thanks!

//ArrowChat Integreation Code //