350x aftermarket bearing carrier

[jaykup]

I got a 350x aftermarket bearing carrier from ebay, http://cgi.ebay.com/ebaymotors/Honda...spagenameZWDVW
and after installing, the sprocket bolts don't clear the bearing carrier.

The only other change I made was a axle from ebay, but that said it came off a "1985 Honda 350x".

Take a look at the pictures to see what I mean. Anyone else had this problem? or am I installing something wrong?

[i58829]

The 85 axle/rear sprocket hub is a smaller bolt circle than the 86's. I haven't put mine together yet but i see now that it might cause a problem or two...

[jaykup]

Yes, it is made for the '86 only. I'm going to shave down my bolts to see if I can fix it that way.

Here is what the guy from ebay said:

Ok, I just checked the catalogs, and it only fits the 1986 350X. We have it
listed wrong on ebay, I will change those listings right now. If you can't
make it work and want to send it back, I will give you a full refund
including shipping both ways, also you will still get the store credit
coupon we originally sent.
Sorry for the mistake.

Charlie Blumberg
CDB MotorSports, Inc.
603-587-0281 - Ph
603-587-0088 - Fax
www.cdbmotorsports.com

Hope this helps someone.

[super90]

This happend to my 200x rad carrier too. Probably from years of use it wore down to the carrier and the bolts rubbed. I made a spacers and put it between the sprocket and bearings. And it also needed the break caliper mount to be grinded down 1/8'' to work. But now its fine and everything works good

[trikerider2oo7]

i have done this on my 85 x...you need to buy an 86 rear sprocket and the bolts for an 86. the bolts are countersunk so they clear the carrier

EDIT: added a pic of mine

[jaykup]

Good idea, I went down to Ace Hardware, and picked up some shorter-head bolts. They clear just fine now. This is on a 1985 Honda 350x, with a 1985 350x axle and sprocket.