At The Back Of The Pack
Arm chair racerAt the back of the pack
well since were talking about clutches i have a problem with the bracket on the case itself... its broken clean off but...there an epoxy THING all over it and the clutch works but....is there way too fix this...can i make a bracket and drill into the case to mount it...thx
Just Too Addicted
Arm chair racerJust too addicted
I would think if you could make a bracket, and grind everything flush with the case, then you could drill maybe four holes (for a solid base) and use screws only long enough to go through the case and you would be good. And use loctite or something to make sure the threads are sealed good. That's what I would look into doing myself, but probably going to have to fab something up if you don't want to replace the case
Loves Corn.
Catch me if you can
do you have the metal clip that holds the cable.. it slips in a groove under the prongs that the cable sits between.. I have a motor that has one tab broke off,, I drilled a 1/8 hole and wired it for safety
At The Back Of The Pack
Arm chair racerAt the back of the pack
that what i was thinking i was just worried about trying it...i figuired that someone might have done it here...thx
Loves Corn.
Catch me if you can
I did not drill through the case..I drilled through the square part where the tabs would be on top of the case
Power User
Catch me if you can
Best thing to do if the stocker is unuseable is to fab up a new bracket that can use the stock outer case bolts and is formed to be where the original cast aluminum bracket was. I did it on my RM125 when it snapped off and it worked perfect.
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
Loves Corn.
Catch me if you can
Originally Posted by Dirtcrasher
the cable is too short for that.. it has to be in the center of the cases
Reply With Quote