Results 1 to 5 of 5

Thread: 200X troubles

  1. 05-29-2003, 06:55 PM #1
    DIGGER DOG
    DIGGER DOG is offline At The Back Of The Pack Arm chair racerAt the back of the pack
    Join Date
    Sep 2002
    Location
    in the sticks s.w ga
    --
    446

    200X troubles

    Ok how do I put this after resto It wouldent run,changed the plug run good for awhile then jus recently it would pop and hesitate at hi speed just slightly now it fires but doesent idle billows smoke (grey maybe white)
    pops and sputters (runs hesitantly and only if i roll throttle).
    I will buy another plug tomorrow,the coil is fine ,reset pulse air gap,need to get timing light and fitting to fit my comp.tester to test compression,plug wire is fine and I know I need to get another carburetor
    I havent taken carb off yet and the plug is off my 350x which isint the right plug its a champion RA6HC instead of a RA6YC but it did run great
    untill now Ill get an NGK tomorrow if they have em in stock .
    So any ideas on what may be wrong ?and is there any thing I havent covered The rings and comp should be fine when it was running good it never smoked so I think the smoke I have now is fuel related.
    83 YTM 200,84 200X,,85 350X basket case,86 350X parts trike,86 350Xroller needs top end, 86 250SX,
    Reply With Quote Reply With Quote
  2. 05-29-2003, 08:01 PM #2
    wanta250r
    wanta250r is offline Just Too Addicted Arm chair racerJust too addicted
    Join Date
    Feb 2003
    Location
    California
    --
    623
    Try cleaning out the carburetor.
    Reply With Quote Reply With Quote
  3. 05-29-2003, 09:16 PM #3
    BLAZERONE22's Avatar
    BLAZERONE22
    BLAZERONE22 is offline Power User Got the holeshot
    Join Date
    Oct 2002
    --
    1,982
    Yep, try the carb. Good Luck!
    1985 350x
    1985 350x
    1985 250r
    200 auto x
    1984 250r
    1982 250r
    85 Tecate
    86 Tri Z
    85 TRI Z
    98Wolverine
    99TRX 300

    I need a 86 250r Headlight lens!!!! Hook me up!!!!









    Westcoasters check out the Florence ride....

    http://www.3wheelerworldforums.com/s...ad.php?t=42267
    Reply With Quote Reply With Quote
  4. 05-30-2003, 05:18 PM #4
    DIGGER DOG
    DIGGER DOG is offline At The Back Of The Pack Arm chair racerAt the back of the pack
    Join Date
    Sep 2002
    Location
    in the sticks s.w ga
    --
    446
    yep yep just got my plug put it in fired on first kick run fine fer a minute or two then started sputtering and smoking again frikkin fouling out my plug carb got worse its dumping too much fuel and fouling out the plug i knew i needed a new carb cause its permatexed together (frankensteined) well there goes $150.00 fer the carb
    83 YTM 200,84 200X,,85 350X basket case,86 350X parts trike,86 350Xroller needs top end, 86 250SX,
    Reply With Quote Reply With Quote
  5. 05-30-2003, 06:31 PM #5
    DIGGER DOG
    DIGGER DOG is offline At The Back Of The Pack Arm chair racerAt the back of the pack
    Join Date
    Sep 2002
    Location
    in the sticks s.w ga
    --
    446
    un frikkin believable I drained the carb and for kicks and giggles I removed the 17 mm nut on the bottom of bowl lo and behold the frikkin main jet just fell out :shock: never the less there was no trash in the bolt
    so I screwed the jet back in cleaned the plug and away we go had a great ride it still pops and hesetates just a little at full throttle but at low and middle runs awsome guess i need to break down and buy a carb. just because I dont like the frankestaind wood screw permatex mcgyver set up.
    83 YTM 200,84 200X,,85 350X basket case,86 350X parts trike,86 350Xroller needs top end, 86 250SX,
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //