83-84 250r spanner wrench

[1upfront]

I made this with a 1/4 inch piece of steel, a cut off wheel, die grinder, drill, angle grinder and a half round *Edited**Edited**Edited**Edited**Edited**Edited**E dited*. I used a spare bearing carrier and traced the shape onto a piece of thick paper then I drew the rest of the tool around it, after cutting the shape out of thick paper I carefully scribed the shape onto the steel and used the above tools to finalize the shape, it took a couple of hours lots of patience and a shoe full of metal shavings.

[tecat-z]

Nice, wonder if the spacing on the 83-84 shocks is the same as liquid models My buddy was wondering if he could still buy the correct tool from Honda for his 86.

[moose 53]

Good job, it can be a lot of fun making your own tools

[1upfront]

Thanks guys, as far as the 85-86 models you might still be able to get new one's but I'm not sure.

[Xowner]

also if you guys are making your own of these were he has the hole to hang it up my buddy made it were you could put a 1/2 breaker bar in there in case you got a stuck one!