Honda 1985 200x wont start...help

[timex69]

hey
Ive got a honda 200x and It wont start. I was riding the other day and it just died. No bark or sputter just died. I took it apart today and split the cases to change a gear that was slipping (2nd gear counter shaft). I checked it over when I had it apart. No stuck valves, bad crank etc. There was shavings in the oil but that was from the gear. Im getting fuel and when I pull the spark plug out im getting fire. The timing is set but it wont even bark. Any suggestions? There was alot of shavings on the magneto and fly wheel but I wiped them all clean.

Help

[ebecme01]

is the plate behind the cdi cover tight and in the correct place? it could have slipped

[timex69]

is the plate behind the cdi cover tight and in the correct place? it could have slipped

The cover behind the pulse generator?

[Havoxx]

The cover behind the pulse generator?

Yea, believe that's what he means, if you took it apart, make sure you put the pulse gen at the right spot, or whatever hits it, not sure on those top models, mine has it on the flywheel, because if it's on the wrong TDC stroke, it will have spark, but the spark will hit at the exhaust stroke and not the intake one, or vice versa, check it with a timinglight if you got one.

[timex69]

ill do that man thanks..very helpful...any more suggestions anyone..could it be my ignition timing is off?

[timex69]

not doubting what you guys said....just wanting all the suggestions I can get.

But If you have fuel fire compression...then timing is the only thing left.

[Bryan Raffa]

make shure the the two bolts on the cam gear are tight..and check your timeing.. it could have jumped

[timex69]

cam bolts are tight

[Bryan Raffa]

streched timeing chain?

[timex69]

also..if i kick it over sometimes it will shoot fuel back out the carb

[timex69]

new timing chain man. im just about to head out and check the cdi plate...how do you know if its set right..its about the only thing i never checked. keep in mind i was ridin it and it just up and died...i switched carbs with another one I had so its not a plugged carb

[ebecme01]

if i remember correctly, you take the timing inspection plug out (on the side case). take the pulse generator cover off. when the timing mark is visible on the magneto or flywheel, the generator should be ponting precisely in the center of the pick-up on the plate. Ive done this but I obviously dont know the name of everything. I started out on two strokes and some of these parts werent there.

[Dirtcrasher]

Is there enough compression to blow your finger off while kicking it??

[timex69]

alright thanks for the help guys..we figured out.

There is a line on the pulse generator that when you put it on should be pointing at the "O" on the cam gear. It was firing when the piston was at the bottom.

Now its time to get rid of the wheeler and head to New Hampshire to pick up at 85 Tecate

[tri-Z ripper]

HUH is it from someone on here!! who is selling there 85 tecate??