Registered User
New to the board
I am currently in the process of restoring a 1980 atc70. I am having the engine cases powder coated and was wondering if I needed to remove the bearings that are pressed into the cases. Will the heat process of powdercoating hurt these bearings? Has anyone else done this?
Power User
4 Wheels? Huh?
i would take them out just to be safe
80s......185 atc, Yamaha tri-moto 200, 85 200x with tons of work
90s......89 Suzuki quad racer 250 (raced 250 A class for 6 years, late 90s.. custom framed 250x with long travel shocks and a built 350x motor.... built Honda 110
00s...... chomeoly framed 350 RX with all the goodies (thanks to my bro)
2012.....Replaced the 350x motor for a 444cc YZ426
WWW.HREATV.COM
Loves Corn.
Catch me if you can
strip them right down bare..seals,bearings,keepers... put a old bolt on each hole too keep the crap out ..or it will be a PITA.. your PCer should have plugs to fit in the bearing races..most do
Got The Holeshot
Arm chair racerJust too addicted
Reply With Quote