Results 1 to 3 of 3

Thread: HELP 250r

  1. 05-20-2008, 10:25 PM #1
    83250r
    83250r is offline New to the board Arm chair racerNew to the board
    Join Date
    Mar 2008
    Location
    tunkhannock, pa
    --
    52

    HELP 250r

    i think the baring where the rod meets the crank is going bad when it is runing it sound like a diesel nocking and i replaced the baring around the rist pin chould it be the other one and when i have the clutch lever pulled it and shift into gears it jumps a little but i have tryed ajusting it everywhere on the cable no help what could that meen let me know its an 83
    Reply With Quote Reply With Quote
  2. 05-20-2008, 10:32 PM #2
    Erics350x's Avatar
    Erics350x
    Erics350x is offline Power User Got the holeshot
    Join Date
    Apr 2006
    Location
    Crestview, Florida
    --
    2,429
    The rod shouldn't have any up/down play
    The person who says it cannot be done should not interrupt the person who is doing it.


    Rides
    85 ATC350X
    85 ATC200X


    My Feedback http://http://www.3wheelerworld.com/...-for-Erics350x
    Reply With Quote Reply With Quote
  3. 05-20-2008, 10:42 PM #3
    83250r
    83250r is offline New to the board Arm chair racerNew to the board
    Join Date
    Mar 2008
    Location
    tunkhannock, pa
    --
    52
    what elts would make it nock like that thow it i check for play befor i put the top half on but i dident feal any but i may have been mistaken
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //