Registered User
New to the board
250r problems
i got an 85 250r. i just rebuilt the whole engine.new bearings,seals,gears,the whole works. I even bored out the top end 20 over,and put allnew wiseco parts in it. but............ now it stop firing!!!! i changed spark plugs, checked all the little plugs and all, but nothing happened. i even changed coil packs and had the stater cleaned. nothing has worked. if any body has any suggestions, i would greatly appreciate it. thanks.
Wires, Hoses, & Digital Wizardry.
Got the holeshot
Start with the basics. Make sure it's getting air & has good compression. Make sure it's getting fuel, and make sure it has spark.
1 thing that happened to me recently: While you had your carburetor off for the engine rebuild, the float might have gotten stuck closed, so it will be getting fuel to the carb, but not into the carb.
Red Rider's Sand Machine Updated 07/23/14
New to the board
Arm chair racerNew to the board
how bout the CDI box ? and BTW this shoud be in trikeslvania not classifides
life is short ride hard and drive fast!
1982 250 r Sold
1985 ATC 70to get a rebuild has too much crankcase pressure and wont shift need piston, rings
1985 ATC 200s(this is my mine again)
need rear foot brake cable cheap tires
1984 ATC 250r project i need stuff bearing carrier, carb, intake, wiring harness
plastics,silencer,clutch perch, light and kill switches
sprocket,handle bars ,handle bar clamps
New to the board
Arm chair racerNew to the board
Check all electrical connections and then RE_CHECK!!!!
1981 250R
1985 200X
1992 Lark Trike!
Reply With Quote