What do I need to do??

**sgp56** · 08-19-2008, 10:02 PM

I have a 50cc engine that the topend was messed up. I had a 110 engine that had a bad bottem end, and they were the same type engine. I put the 110 cylinder and piston and head on the 50s bottem end. everything bolted right up but the only thing that gave me a problem was the cam chain but i just switched them out. Im alsomst done putting it together and will try to start it soon. I was wondering what problems i might run into with the conversion. Can the 50s bottem end handle the 110? I plan on using the 50s carb but will i need to rejet? Any help appreciated.

**scooterroo** · 08-21-2008, 08:16 PM

never heard of anyone doing this before..

**Erics350x** · 08-21-2008, 09:43 PM

you' be better off running the 110 carb

**devilman** · 08-21-2008, 09:50 PM

we need to see

of this

**sgp56** · 08-23-2008, 12:12 AM

i got it all together and it runs. i had to adjust the carb a little and move the needle jet down 1 notch. Now it runs great. The only problem now is i have a oil leak. Im going to put some gasket maker on where it leaks and hopfully that works. also the throttle cable broke so i replaced it and now when idiling it sputters but when i ride its great. what could that be?

**Erics350x** · 08-23-2008, 01:00 AM

air leak, slow jetting, mixture screw

**The Goat** · 08-23-2008, 02:02 AM

the fact that your name is james

Thread: What do I need to do??

Thread Tools

What do I need to do??