At The Back Of The Pack
Arm chair racerFirst time rider
Tried a search and it's down? Any-way here's my question:
Reassembled my engine and when kicking it over it just pops out the exhaust? I's the timing somehow off? I put the dot and scribe mark on the flywheel in the correct positions, but maybe the cam is 180* out?Any ideas?
New to the board
Arm chair racerNew to the board
Could be just one tooth off POSSIBLEY h
Power User
Got the holeshot
There should be a T mark on the flywheel to line up with the notch in the plug. Your valves should be closed a TDC.
The person who says it cannot be done should not interrupt the person who is doing it.
Rides
85 ATC350X
85 ATC200X
My Feedback http://http://www.3wheelerworld.com/...-for-Erics350x
Power User
Catch me if you can
If it's an 85 or under then it's easy to set the cam 180 out....
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
At The Back Of The Pack
Arm chair racerFirst time rider
Tried the cam 180 but didn't work. I'll check the timing again but I thought it was right on.
Power User
4 Wheels? Huh?
my original 200x would run with the timing 10 degrees advanced or so...so I'm thinking it's a few degrees retarded.
At The Back Of The Pack
Arm chair racerFirst time rider
Does anyone have a pic of their stator plate? I'll move it back 180* (where it should be) but I have no clue where to adjust the plate.
Reply With Quote