First Time Rider
Arm chair racerNew to the board
Hi,
My 83 110 was fully torn off the frame and put onto another (the frame snapped). So with all the work it wasn't bad however we couldn't get the brakes back on. We left it off. After all it's a 110 and I can control it for the most part by breaking with the engine (not too good). Is there any DIY custom breaks? Could I swap a front end and have front brakes at least?
[Blue]1983 Honda ATC 110
1985 Honda ATC 350x Fixer
Power User
The day begins with 3WW
Well, you have to show why the brakes won't work. It doesn't make any sense to me. I know the earlier frames brake set up is pretty close. I'm sure someone on here has the parts to make your brakes work. But if you can find a 185s front end you can have the front brakes you are looking for, but the parts for the rear brakes can't be that hard to get. Lots of people on here have parts trikes and I'm sure someone on here could get your brake parts pretty cheap to you. Put an ad in the classified section and see what happens, but you have to know the year of your frame you put your parts into.
Just Too Addicted
Arm chair racerJust too addicted
detailed pictures would be nice, then we could go from there
1986 ATC250r
1984 ATC70
At The Back Of The Pack
Arm chair racerFirst time rider
a direct bolt in front fork assembly with brakes is the 84-87 125M, if you want front suspension as well try a 185s/200s 83-86 front end. i beleive you have to do a little mod work to make the 185s/200s work but is very minimal. otherwise look for a 125m front end.
Reply With Quote