Results 1 to 3 of 3

Thread: Anybody have any luck fabricating an intake for a tecate?

  1. 02-21-2009, 12:27 AM #1
    Hoosier_Daddy's Avatar
    Hoosier_Daddy
    Hoosier_Daddy is offline Got The Holeshot Arm chair racerJust too addicted
    Join Date
    Jun 2008
    Location
    NE Indiana
    --
    1,067

    Anybody have any luck fabricating an intake for a tecate?

    They seem to go bad easily and are hard to obtain. Is it hard to make one that will work?
    Last edited by Hoosier_Daddy; 02-21-2009 at 12:38 AM.
    https://t.me/pump_upp
    Reply With Quote Reply With Quote
  2. 02-21-2009, 01:08 AM #2
    ScottZJ's Avatar
    ScottZJ
    ScottZJ is offline Power User Teaching quads a lesson
    Join Date
    Oct 2002
    Location
    Bartlett TN
    --
    3,083
    Intake? so you can run a straight filter system?? If thats what you are looking for, just use the KX250 instake (bolts right up) and this will angle the intake so you can put a straight on filter and will not hit the rear spring.

    See the KX intake is angled quite a bit
    86-87 Tecate ROCK!

    Ride fast...........brake late............and Slide the rear!
    Reply With Quote Reply With Quote
  3. 02-21-2009, 01:27 AM #3
    cr480r's Avatar
    cr480r
    cr480r is offline Power User Got the holeshot
    Join Date
    Nov 2006
    Location
    southern oregon
    --
    2,338
    the angled KX boots dont fit the '84-'85 Tecates near as well as they do the '86-'87... An aluminum intake would be very simple to fab... I would machine the intake tube to use a replacement rubber boot from a boyeson rad valve... i would match the flange to a '86 reed stuffer
    2-stroke lover
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //