Page 2 of 2 FirstFirst 1 2
Results 16 to 18 of 18

Thread: installed brand new stator/flywheel runs 30ft dies (tecate)

  1. #16
    shadix518's Avatar
    shadix518 is offline At The Back Of The Pack Arm chair racerFirst time rider
    Join Date
    May 2009
    Location
    Wichita, Kansas
    --
    198
    deceakl where at in Kansas you at?
    1985 Atc 250sx my first.....
    1985 Tri-Moto 200......SOLD
    1985 Yamaha 225dx.....


  2. #17
    Join Date
    Aug 2008
    Location
    OK
    --
    5,450
    Coffeyville
    Rides:
    1986 ATC250R (sectional pipe and Klemm Research silencer)
    1986 ATC250R (Desert Bike, WAX-ON seat, Dual Cibie lights, Steering Stabilizer)
    1979 ATC110 (Bandito frame and forks, Turbo wheels, disc braked)
    1982 ATC70 (Lifan manual 125)
    1987 LT80 (piped, widened)


    My feedback thread
    http://www.3wheelerworld.com/showthr...ack-for-dcreel

    RIP Trace.. Godspeed.

  3. #18
    Join Date
    Sep 2005
    Location
    MICHIGAN
    --
    2,027
    Sounds kinda like when my stator crapped out. It would run for a minute or two or 5 then just die like it was out of gas, but would start first kick every time. Parked it for the winter. I tried new carbs and it would not even start. As soon as I put a KX250 ignition on it, fired right away. I have yet to ride it and tune the carb and check to see if the crank seal is bad.
    86 T3
    84 T3
    86 KX250

//ArrowChat Integreation Code //