New to the board
Arm chair racerNew to the board
I just installed brand new rear end bearings and there is still slop in my axle. Its like the inner diameter of the bearing is larger than the axle diameter. The bearings themselves have no slop...it is around where the axle slides through the bearings. I tried to different axles and they both have the same problem. Any suggestions?? Thanks,
-Chris
If it ain't broke, fix it 'till it is!
1987 250sx
1983 250R (project)
Check my feedback before buying from me
Catch me if you can
sounds like the bearings are incorrect I would contact whoever you got them from.
Power User
Catch me if you can
Are we talking a bit of blay or a TON of play? Were the axle journals rusty or worn at all?? Measure them with a micrometer and you may find them undersized a few thousandths. It only takes a little bit to be quite a bit when your grabbing the end of the axle or the tire. The center sleeve can also cause an issue but thats more side to side play until it starts flapping around and ruins your new bearings....
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
Power User
The day begins with 3WW
is where the races on the axle scored or worn and is the carrier worn wher ethe outer races go ??? what trike is it also may help.
ok here goes, 85 atc70,2 84 atc70's 83 alt50,83 atc110 , 70 us 90 parot green, 85/86 350x garage queen, stock rider 85 350x, project 85 350x 85 250r drag bike, 2 85 250sx's, alt185, , scat tracker?99blaster,85 250r rider,85 250r ice racer project ,93 kx500,99 xr200r, 91 dr250s ,89 lt500 quadzilla,88 lt250quadracer, 88 trx250r race full on race quad,, 01 yamahakodiak400, kawaki kd100,lt50 for my doughters,93 300ex, 230 quadsport, lt185, lt250 quadrunner,84200s, is that enough?
Reply With Quote