Registered User
New to the board
Aight, I got a 85 Yamaha Tri-Z and the front brake caliber is shot, and I was just wondering how much a used one would got for (a ballpark figure) and/or if there are any other makes' front brake calibers that would bolt to it. Thanks!
P.S. I have the same problem with the rear mono shock, so if you happen to know anything. lemme know!
At The Back Of The Pack
Arm chair racerFirst time rider
you could use the whole brake assembely off of a pit bike i think but not 100% sure im sure someone on here knows thats the setup i will be using on a 200x front end i will be putting on my 250sx
1985 Atc 250sx my first.....
1985 Tri-Moto 200......SOLD
1985 Yamaha 225dx.....
Power User
Got the holeshot
Here is a Tri-Z parts swap thread that will help.
http://www.3wheelerworldforums.com/s...ad.php?t=16277
Expect to pay anywhere from 30$-75$ for a caliper. The back does fit the front and vice versa also.
Check our classified section too. Couple of Z's being parted out.
1981 ATC 70
1978 ATC 90
1985 ATC 250R
1993 modded Banshee."Sounds like an Indy car on crack"
www.cosmicquads.com
Reply With Quote
