At The Back Of The Pack
Arm chair racerFirst time rider
i am tearing down my 86 350x to do a restore on it and im powdercoating everything on it. i noticed on the foot brake lever for the rear brakes there is like a rubber bushing or something inside of it is there anywhere i can get one for it? im pretty sure it will probably melt if i put it in my oven when i powdercoat it.
Power User
Teaching quads a lesson
Those are actually seals to keep dirt out.
OIL SEAL (19X25X3)
91206-965-003, Each 2
http://www.servicehondapsn.com/fiche...86&fveh=131333
Power User
The day begins with 3WW
You'll need four of them. The pivot arm that connects the brake lever to the master cylinder has two of them also.
'86 ATC 250R, Build Thread http://www.3wheelerworld.com/showthr...highlight=250r
'86 "Factory Tri racing" Tri-Z http://www.3wheelerworld.com/showthr...b-Top-Tank-ect
Pile of Tecate Parts
My Feedback Thread: http://www.3wheelerworld.com/showthr...edback-for-bkm
Power User
Catch me if you can
I use o-rings
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
Registered User
New to the board
Super old thread but do the orings work?
Power User
The day begins with 3WW
just measure the seal size order them from mc-master carr. honda might not even sell them anymore. Not like they ever really made them awayway. its just a metic seal size.
Reply With Quote