Activity Stream

All the Maier front fenders for the 350x that I've seen are crooked when mounted and viewed from looking strait on from the front. Must be the mold....

I spoke with Tammy and purchased another seat with a decent pan and all the studs. She has a useable foam for me and the pan is being shipped direct...

The gold would be tricky. That’s a good anodize finish on those isn’t it?

Suzuki LTA400

:D :beer :welcome:

It's a very special old tire but it's junk now. And, no one likes running a tube...

Andy, my friend. Why wouldn't you go grab a 10mm and 12mm wrench? That's pretty much all you need to remove the forks. But, the wheel has to come off...

You mean the lever? I would imagine a wave washer against a rotating lever would wear it out.

Australia?? Poor fella, will you even be able to ride it? That country seems to be treating it's people pretty lousy these days, but pampering...

If your pan is nice, the studs are a piece of cake to change/fabricate. Finding a good pan and good foam is the harder part. Tammy should still be...

Those rims are hard to find without any damage these days, and they aren't cheap. You can probably smooth down the outer lip very carefully with a...

For ANY plastic, just look underneath (or the back side) and it's easy to tell the difference from Vac Formed to plastic injection molded.

let’s try this way.

Can anyone tell me if this front fender is Maier or OEM? Rears are easy. I can’t tell the fronts apart…