Aftermarket bars for ATC 70

[pismorat]

I found a set of bars on craigslist that were used on an ATC (unknown type), but I am thinking of putting them on my ATC 70. They are about 30" wide and 7.5" tall...will this work??

[shortline10]

Should but your throttle cable might be to short .

[pismorat]

Where would I get longer cables...probably for throttle and brake?

[Macs]

On my 70 build i used a set of moose bars for a cr250. It had the bend on wanted but of course my new cables were a bit too short. I ended up cutting 2" off of each side of the bar, then put my handgrips on. This made the cable long enough and also made the reach less for the kiddos.

[Tri-ZNate]

extended brake and throttle along with anything else you need http://www.sterdyproducts.com/productcart/pc/viewCat_P.asp?idCategory=32

[Dirtcrasher]

I run ATV high Pro-Tapers.....

No cable changes, all stock.

[86trizinger]

I am running Pro Taper mini bars on mine. Cables are just long enough.

[oneroom42]

i am running an old set of bmx bars and i made the cables out of a bmx brake cable. dratv.com sells the solder on pieces for the end of the cable which goes in the carb.