1st gen 2nd gen parts interchange

[dman10]

I have a complete 85 X with a crapply swapped in 2nd gen X motor. When they did the swap they butched the frame, so I was wondering if the swingare, front forks and etc would fit a 86 frame with little/no mods?

[Jmoozy27]

The triple will fit but you will need the grind the steering stop off of the frame. The swinger will also swap but you will need to make a chain tensioner. I did mine with rear caliper bracket, 10mm bolt and a skate wheel. Not hard at all, just have to figure it out.

[Jmoozy27]

Shortly after I took this pic I went up on the sprocket size and shifted the tensioner towards the front sprocket.http://www.3wheelerworld.com/attachment.php?attachmentid=225337&stc=1http://www.3wheelerworld.com/attachment.php?attachmentid=225338&stc=1

[atc300r]

I made 2 from lawnmower parts and skateboard wheels.This one is on my 81 250r.225339 225340