What other engine fits in a honda 200

[3Dwheeler]

hey all engine is toast on one of my 3wheelers. Insted of fixing it i thinking of putting an other engine in. It's a honda 1982 200 chain drive, pull start. No electric start or shaft drive.

Any ideals?

[dickieg89]

Would you want to go smaller than the 200cc? The 185cc should bolt right on.

[russell56443]

Hey this a link to a past post which I found helpfull,tells what will interchange for them all:D
http://www.3wheelerworldforums.com/showthread.php?t=56838

[hondaatcvabeach]

A 185s would work....I put a 200 motor in my 200x so I think a 200x motor would go into a 200. You may have to use the 200 intake. And you would have to change the guts of the stator, or use a 200x whire harness. (I would just swap the stator though.) Not to hard.

[3Dwheeler]

cool while looking for an engin my freind called me he would give me his Honda cr480 just to make room in his shed. the Front end is smashed to *Edited**Edited**Edited**Edited* including tank but the engine is good the cr480 is basicaly the same as the cr500. Now i am looking for an atc that would fit this without to many modification. lol going from one project to an other.

[MTS]

cool while looking for an engin my freind called me he would give me his Honda cr480 just to make room in his shed. the Front end is smashed to *Edited**Edited**Edited**Edited* including tank but the engine is good the cr480 is basicaly the same as the cr500. Now i am looking for an atc that would fit this without to many modification. lol going from one project to an other.
Try and find a 83-84 honda 250R, Cr480 will go in with some work, and a custom pipe.

[3Dwheeler]

cool thanks I am now looking for a 250r fram and the head for a 200 Should be awsome when i am done 480 cc 3wheeler that should boot around the corner realy good. :p :lol: