1983 atc 200 rear axle bearing help needed

[automated11]

Ok so I down loaded the manual and have everything apart on the rear axle. I removed the seals but my question now is can I drive both bearings and spacer through one side or do I need to try and remove by pounding a drift from either side through the carrier? I have tried to do this and their pretty stuck. So I tried heating up the carrier on the sprocket side with propane with still no luck. I tried the search but I couldnt find much on the subject related to this model since I belive the carrier is steel and not aluminum.

Thanks for your time,

Jason

[MonroeMike]

The bearings come out their respective sides.

[automated11]

TTT any ideas on getting them out? They have to be original and were VERY crunchy. I might be able to get a slide type bearing remover from a neighbor and it has a hook on the end to grab the back of the bearing.

[86trizinger]

I usually use a punch and them out from the other side. You could also try letting it sit a while with some penetrating of some sort to help break down the build up.

I usually have more problems getting the axle nuts off then the bearings out

[Leadfoot71]

TTT any ideas on getting them out? They have to be original and were VERY crunchy. I might be able to get a slide type bearing remover from a neighbor and it has a hook on the end to grab the back of the bearing.

I just pulled the bearings out of my '82 BR last week and that is what I used. Worked great! Also, if possible, leave the bearing carrier in the frame. Holding on to the bearing carrier while slider ing stuff doesn't work too well.