1984 Axle Collar

[dksix]

Should my 200x have a collar between the bearings inside the carrier? I don't remember one coming out of mine and I'm not finding one to put back in it but a picture I found in the manual shows it should have one but the picture is a different swing arm. The one in the picture is like from round tubing and mine is rectangle tubing. The manual says it's for 83-85.

[hillbilly 200x]

Hey dksix I just had my 83 200x axle apart and there is one long collar and mine had two little ones there is a ling with a blow aprat for my 83 http://www.cheapcycleparts.com/model...ssemblies/3648

[ATC Dude]

The 83' 200x used a round tubing swingarm. The 84' and 85' were rectangular. That is why you see a picture of a different swingarm in the manual.

[dksix]

Does the one with the round tube use an axle collar and the rectangle swingarms not use a collar? If I have to have one, I can't put mine back together without it but I've not been able to find any pictures with a collar in it. I've found everything else for sale but not that collar???

[MonroeMike]

http://www.xtremeusa.com/fiche_secti...1984&fveh=2805

[dksix]

http://www.xtremeusa.com/fiche_secti...1984&fveh=2805

Thanks, Mike. Does anyone have one of these laying around who could measure it for me? I've not found one for sale and they are shown as discontinued, and I really don't want to wait to have one shipped. If I can get good measurements, I'll make one. ID and OD shouldn't be too critical as long as it I get the OAL correct.

[Grizzlypeg]

There is one in my 84. Just a piece of pipe that fits over the axle,but the length must be fairly critical. Can't measure it as its assembled and conceiled.