Registered User
New to the board
I have a 1985 Honda 200x and we cleaned the carburater out and put it all back together and now it idols VERY scary high and the idol screw doesn't help it either way.The thumb throttle is also loose as in it pushes easily in about halfway before you feel resistance.Any help would be great thanks in advance.
Power User
Catch me if you can
Sounds like the slide is in backwards or hung up. Loosen the top cap and check it out. Remove the Airbox and peek inside to see if it's hung up....
Sounds like it is.
The slide is connected to the cable and the doo dad that has the spring and needle on it.
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
Registered User
New to the board
Well I think that worked.It maybe cold natured and need to be warmed up before it will stay running idling.Right now you have to give it gas to keep it running.
Kindergarden Speller
4 Wheels? Huh?
mine did that too. some are just cold blooded. or its just a tad on the rich side but all and all its not too much to worry about.
down to parts because i no longer have a place to ride trikes.
GIT IT RAAAGGGGG !!!!
Power User
Teaching quads a lesson
Some engines are like that, you just need to get the heat flowing around before they will idle correctly.
LED obsessed
2015 Yamaha FJ-09
Registered User
New to the board
Well its still doing like before.That fixed the throttle but it still will not stay running unless you give it gas even if its warm.Gonna clean out the gas tank and maybe do the carburater again.Do any of you know something else that can be done?
Power User
The day begins with 3WW
air screw adjusted properly?....when you removed the airscrew to clean the carb (assuming you did), did the needle on the screw get bent or mushroomed at the tip? was it set properly again? (meaning NOT where it was when disassembled as it may have been reset to make a dirty carb run better....check the setting
also sounds like pilot jet may still be clogged....sometimes "cleaning" merely moves debris to another part of the carb clogging it up somewhere else
download a manual from here....will help you tremendously and its free
Registered User
New to the board
Which screw is the air screw?
Last edited by Dogsoldier; 10-24-2011 at 12:10 AM.
Power User
The day begins with 3WW
Pages 103-104 (it's called a idle mixture screw on these pages).
http://www.3wheelerworld.com/showthr...)-Service-Data
Registered User
New to the board
"A lightly seated posistion"...So I tighten it but just barely?...Can I just unscrew it all the way out to check the tip without screwing anything up ?Or do I have to take the whole carb off again?
Power User
Lord of the trike
Yeah tighten it till it bottoms out, but don't crank down on it
Rob
Registered User
New to the board
where are the manuals?
Power User
The day begins with 3WW
Reply With Quote
