atc 250r Questions

[william16339]

i dont mind it,,i was just wondering if its normal lol

[william16339]

there are no sharp turns or kinks

[william16339]

oh, you said you needed a fork seal driver though corect?

[200x350xtriz250]

yeah i put 10 just to open up the sight lol

Well enjoy your time here...can't say I didn't try lol lol

[william16339]

i just changed the swingarm bearings......hmmmmmm im not sure ill put it on the jack tomarrow and see....but im pretty sure its carier...bc mine is all beat up,,,,,but if i put new bearings in it,,shouldnt it be fine?

[RIDE-RED 250r]

If the carrier itself is worn to the point there is slop between the outer race of the new axle bearings and the inside bore of the carrier then a new carrier is in order. Sometimes people will keep on riding on a bad set of axle bearings, and then at some point the bearings will grenade and the sprocket and/or brake rotor hub will make contact with the carrier housing ruining the carrier. I have seen it more times than I care to count.

Find out exactly where the slop is and go from there..

[RIDE-RED 250r]

I used a piece of PVC pipe I just happened to have laying around that happened to be the perfect size.

It needs to slide over the fork and contact the seal without dragging in the lower fork housing.

[william16339]

thankyou alot

[RIDE-RED 250r]

I use a shorty lever with no issues, to some people my lever pulls pretty hard.

[Xowner]

I just combined 10 of your threads together..... Please keep like topics together.

[headache044]

I like black frames, because they match with almost any color plastics, jmo.

[j68nm9]

I did mine in red and was very happy with the results.

[JacobM]

Same here. I went with Red. turned out great.