Aftermarket Suspended ATC185s: likely original intended use?

[Ol Deuce]

I make an adapter that will allow you to install a 200x tree to the 185s and if you want the fat tire it also works with the 1st gen R and 250sx tree!

Ol Deuce

[kiser]

That's a good idea! What's the price tag on them?

[Ol Deuce]

50 bucks +5.85$ flat rate to your DOOR!! Ol Deuce

[captainweezy]

well i had one and used it mainly in the dunes, and even ran it in an enduro or two in the desert. Stock motor with an aftermarket carb, filter, supertrap pipe, and fox shock, without a headlight though.


Working on bringing this one back to life. RH image is how I found it in flat track trim (the engine is a pull start XR200) . LH is how I'm rebuilding for the desert or using paddles for the sand (185S motor while the XR is being gone through). Hope this helps.

I have never heard of a pull start 200x but maybe I should!

[RapidRick]

I have never heard of a pull start 200x but maybe I should!

Sure you have...that's where they drop a 185/185s/200 ATC motor in a 200X chassis.....I believe they call them an AutoX. I've done several of those, however they are not what I'm referring to.

I'm referring to an XR200 motorcycle motor with a hand operated clutch, with out a kick starter on the right side, and a Pull Start on the left. Below is a link for some additional reading.

http://www.3wheelerworld.com/showthr...ight=nicholson

[captainweezy]

I have had an auto x before but the install is awesome. I have plates in my arms but my legs and feet are fine. That's what I'm talking about. Just so happens I have a couple x motors too. I can't believe I missed that post. Thanks for posting.