Can anyone tell me, when i put my trike into gear.. first... it lurches bad .Every once and awhile it will shift hard to when im goin thru the gears , is thair anythig i can do to stop this?
First Time Rider
Arm chair racerNew to the board
cluch 200m
Can anyone tell me, when i put my trike into gear.. first... it lurches bad .Every once and awhile it will shift hard to when im goin thru the gears , is thair anythig i can do to stop this?
My keyboard has no punctuation keys
Arm chair racerJust too addicted
back off the throttle or turn the idle down
First Time Rider
Arm chair racerNew to the board
Adjust the clutch. There is a screw with a 14mm nut on it on the brake pedal side of the engine (clutch cover). I am pretty sure you loosen the nut and turn the bolt ccw until you feel some resistance then back it off an 1/8- a 1/4 turn and tighten the nut back up (you need to hold the screw from turning while you tighten) Good luck and it should work like a charm!
Power User
The day begins with 3WW
^What he said.
From the manual - Loosen the locknut, turn the adjusting screw counterclockwise until resistance is felt. Then turn the adjusting screw clockwise 1/4 turn and tighten the locknut.
First Time Rider
Arm chair racerNew to the board
sweet thanks guys
First Time Rider
Arm chair racerNew to the board
Ok i made a sad atempt to adj the cluch but the jam nut wont spin loose of the stud , looks like im goin to have to add a little heat
Power User
The day begins with 3WW
I've had the same problem. On one, I was able to grab the end of the adjusting screw with vise grips (one side of the screw slot was broke off and the threads were jacked anyway) and got it loose. On the other, I had to take the side cover off.
Reply With Quote