Results 1 to 7 of 7

Thread: HELP!! I have problems with my Yamaha Timberwolf

  1. #1
    Join Date
    Jun 2009
    Location
    Twin Cities, MN
    --
    3

    HELP!! I have problems with my Yamaha Timberwolf

    I have a 1995 Yamaha Timberwolf 250cc, 2wheeldrive.
    It cranks over just fine, but won't start.
    If I pull start it, it will start and stay running, but as soon as a shut it off it won't start again.
    The spark seems a little weak if you ask me, compared to my 200cc dirtbike. I have replaced the CDI, and Coil and wire. But not the windings in the engine.

    PLEASE, any sugestions???????
    Thanks
    Erik

  2. #2
    Join Date
    Feb 2004
    Location
    Tionesta, PA
    --
    5,747
    have you replaced the spark plug?
    RIP - Yamahondaman!! You will never be forgotten!
    RIP - Sam Brehm!! Gone but NEVER forgotten!
    RIP - Sandpuppi101 - You will live on in my mind - I miss you friend!

  3. #3
    Join Date
    Jun 2009
    Location
    Twin Cities, MN
    --
    3
    Yes, I replaced the plug. I also checked the timing chain, and its fine.
    This has been going on for a few months now.
    I just went back out today and found that there is NO spark now!!! I did some testing with my multi meter and I think that the pickup coil in the windings is bad.
    Any other ideas????

  4. #4
    Join Date
    Dec 2008
    Location
    Monroe MI
    --
    5,787

  5. #5
    storm_impulse is offline At The Back Of The Pack Arm chair racerAt the back of the pack
    Join Date
    Sep 2007
    Location
    west virginia
    --
    291
    Quote Originally Posted by elfboy View Post
    Yes, I replaced the plug. I also checked the timing chain, and its fine.
    This has been going on for a few months now.
    I just went back out today and found that there is NO spark now!!! I did some testing with my multi meter and I think that the pickup coil in the windings is bad.
    Any other ideas????
    If the pickup coil is bad then I would say there is your problem.
    1986 atc 250R. needing alot of parts. winter projet!

    1988 lt 250r quadracer. building now.

  6. #6
    Join Date
    Jun 2009
    Location
    Twin Cities, MN
    --
    3
    Well, I looked at the kill switch, inside and out, and it looks like it's working to me.
    I have test the windings before and sometimes I get good readings, and sometimes bad!
    Anyone know where I can get a used one cheap?

  7. #7
    Join Date
    Dec 2008
    Location
    Monroe MI
    --
    5,787

//ArrowChat Integreation Code //